Ex enclosure builder
Choose the enclosure and size, add the entries, cover devices and terminals, and send it to Bankhead Control Systems for a quotation.
Opening the tool…
Design your Ex enclosure, checked as you go
Choose a BARTEC EJB, EJB-X, EJC, GUB, ESI, ESP or TNCN enclosure and size, add cable entries face by face, push buttons, lamps and windows on the cover, and terminals. Drag every hole and device into place on a drawing to scale. The builder checks it all against BARTEC's machining limits as you work, then sends us the full specification and layout for a quotation. Save designs to your account and follow each quotation.
Checks it runs (example)
- !Flameproof entries need Ex d glands chosen by BS EN 60079-14 clause 10.4.2 (see the gland selector). Unused holes are closed with certified blanking plugs.
- !Currents given: we'll check the terminals' ratings and the enclosure's heat limit against its certificate.
- ✓Zone 1: BARTEC EJB is certified for Zone 1 / 2 (gas) and Zone 21 / 22 (dust).
- ✓Bottom: the entries fit.
- ✓Window F3 (110 × 75 mm) fits the EJB-51 cover.
- ✓Cover: the devices fit.
What you get
- A design checked against the enclosure maker's limits as you go, so it can be built
- Every face laid out to scale, with each entry, device and window where you want it
- Designs saved to your account, a quotation in one click, and its progress to follow
Easiest on a tablet or computer. You can start here, save to your account and finish on a bigger screen.
Not sure which enclosure? Use the enclosure guide first.
6. Layout
Drag the cable entries, cover devices and windows to where you want them. Each face is drawn to scale; the dashed area is where holes may go. We'll check the final layout with the quotation.
Touch a hole, device or window, keep your finger still for a moment and it lifts just above your fingertip, with guide lines and its position, then slide to move it. A quick swipe scrolls the page as normal. Tap once to select it, then use the arrows to move it a step at a time. To line up several, press Select several and tap each one. Each face is drawn to scale; the dashed area is where holes may go. We'll check the final layout with the quotation.
7. Inside the enclosure
A mock-up of the terminals on the DIN rails, seen from the front with the cover off. Dashed circles are the cover devices reaching in behind the cover: red where one would hit the terminals.
Terminal Earth End plate End stop
